Find Active Proxy using Access Driver

Guide on How to Find an Active Proxy

There are two things you need for this is:

1. Accessdriver Program - http://www.accessdiver.com/php/getad.php

2. A list of proxies, you can either make your own or use one below:


After the installation, open up the program and click on a pop-up to close it.

On the top left hand corner you will see "My Skill", Change it to "Expert"

Click on the "Proxy" tab, then "Analyzed proxies" tab.

Click on the "Folder" to load a list.

After the list is loaded, near the bottom right hand corner, tick "Use GET method..." and change you "time-out" to any between 4-6 seconds.

Now, advance to the next tab "Analyzer Settings".

Under the "Auto Deletion", tick on everything EXCEPT the last two boxes (which include the levels)

Everything is all set. Go back to "Analyzed proxies" and click on "Speed/Accuracy Tester"

After it is done checking, you can sort out the "delay" from fastest to slowest.

DONE.

 

nice guide keep up the good work man

 

thanks alot,
i hope that help alot of ppl.
most of the proxy you get from the site, either slow or inactive.

this prog, can find active and the lowest delay time!!

 

I wrote a picture good for it, and you forgot to add confidentialiy test.

 

Awesome guide. I've been iced because a proxy didnt work, and this was a ton of help :yup:

 

The link in the top post is no longer functional here is a working one.
[url=http://www.brothersoft.com/ac...w.brothersoft.com/accessdiver- ... 63984.html[/url]

nice guide it helped allot thanks.